An appliance problem starting right after a house move, a new detergent or additive, or a water/gas/power supply change should be checked against that specific change first. For electric-dryer heat circuit, first test Timed Dry, reset both breaker poles once and verify exterior airflow.
What this covers
- electric-dryer heat circuit with this exact failure state
- Diagnosis across cycle setting/airflow versus 240-volt supply, heater and temperature controls
What it does not cover
Try in this order
0 of 4 completedCapture the exact failure state
ReversibleNote exactly what changed — installation, supply type or product used — and confirm it worked immediately before. Expected behavior: receive both supply legs and cycle heat through protected elements.
Isolate the component boundary
ReversibleTest Timed Dry, reset both breaker poles once and verify exterior airflow. Test with the previous product or a factory-recommended one, or verify the new supply connection matches the appliance's requirements. Boundary to separate: cycle setting/airflow versus 240-volt supply, heater and temperature controls.
Correct only the proven cause
ReversibleCorrect household power/vent or service internal heater/controls. Correct the installation, switch back to a compatible product, or arrange service for a supply mismatch that cannot be user-corrected.
Verify and stop safely
ReversibleRun one complete normal cycle under the new conditions and confirm normal results. Stop for breaker trips, hot plug, arcing, smoke or damaged cord.
Evidence ledger
Sources behind this answer
Exact questions