A cycle that takes noticeably longer than normal usually reflects load size, water temperature/pressure, or a sensor extending the cycle, not a failing motor. For dryer exhaust airflow, first run briefly and compare airflow/temperature at the exterior with the duct inspected.
What this covers
- dryer exhaust airflow with this exact failure state
- Diagnosis across lint screen/internal path versus transition duct, wall vent and exterior hood
What it does not cover
Try in this order
0 of 4 completedCapture the exact failure state
ReversibleTime the cycle against the manufacturer's stated duration for that exact setting and load size. Expected behavior: move heated moist air through the full vent to the exterior.
Isolate the component boundary
ReversibleRun briefly and compare airflow/temperature at the exterior with the duct inspected. Run the same cycle with a smaller, standard test load and normal supply conditions. Boundary to separate: lint screen/internal path versus transition duct, wall vent and exterior hood.
Correct only the proven cause
ReversibleClean the full path and correct crushed, long or unsafe ducting. Adjust the load size or cycle selection, or correct the supply condition — water pressure, temperature or airflow — causing the extension.
Verify and stop safely
ReversibleRepeat the same cycle and confirm the duration returns to the expected range. Stop heated use for weak airflow, excessive heat, burning odor or blocked vent.
Evidence ledger
Sources behind this answer
Exact questions