A cycle that takes noticeably longer than normal usually reflects load size, water temperature/pressure, or a sensor extending the cycle, not a failing motor. For gas-dryer ignition and flame, first confirm valve open and observe ignition behavior externally during Timed Dry.
What this covers
- gas-dryer ignition and flame with this exact failure state
- Diagnosis across gas supply versus igniter, valve/coils, sensor and vent
What it does not cover
Try in this order
0 of 4 completedCapture the exact failure state
ReversibleTime the cycle against the manufacturer's stated duration for that exact setting and load size. Expected behavior: ignite controlled flame only with airflow and safety conditions satisfied.
Isolate the component boundary
ReversibleConfirm valve open and observe ignition behavior externally during Timed Dry. Run the same cycle with a smaller, standard test load and normal supply conditions. Boundary to separate: gas supply versus igniter, valve/coils, sensor and vent.
Correct only the proven cause
ReversibleCorrect only external supply/airflow and use qualified gas service internally. Adjust the load size or cycle selection, or correct the supply condition — water pressure, temperature or airflow — causing the extension.
Verify and stop safely
ReversibleRepeat the same cycle and confirm the duration returns to the expected range. Leave and call the gas utility/emergency services for strong gas odor.
Evidence ledger
Sources behind this answer
Exact questions