A cycle that takes noticeably longer than normal usually reflects load size, water temperature/pressure, or a sensor extending the cycle, not a failing motor. For dryer moisture-sensor cycle, first compare the same towel load on Timed Dry and Sensor Dry.
What this covers
- dryer moisture-sensor cycle with this exact failure state
- Diagnosis across small/mixed load versus sensor bars, airflow and control
What it does not cover
Try in this order
0 of 4 completedCapture the exact failure state
ReversibleTime the cycle against the manufacturer's stated duration for that exact setting and load size. Expected behavior: sense damp fabric contact and end when the load reaches target dryness.
Isolate the component boundary
ReversibleCompare the same towel load on Timed Dry and Sensor Dry. Run the same cycle with a smaller, standard test load and normal supply conditions. Boundary to separate: small/mixed load versus sensor bars, airflow and control.
Correct only the proven cause
ReversibleClean sensor bars by approved method and group similar fabrics. Adjust the load size or cycle selection, or correct the supply condition — water pressure, temperature or airflow — causing the extension.
Verify and stop safely
ReversibleRepeat the same cycle and confirm the duration returns to the expected range. Service cycles that end immediately with a normal damp load and clean sensors.
Evidence ledger
Sources behind this answer
Exact questions