Direct answer
For the Whirlpool WRT318FZDW top-freezer refrigerator, the first wet location separates supply/filter/valve, defrost drain, ice maker and condensation causes. First, dry all areas and locate where water first appears.
What this covers
- Whirlpool WRT318FZDW top-freezer refrigerator (WRT318FZDW)
- Whirlpool WRT318FZDW top-freezer refrigerator. Whirlpool’s own specification for this model states no built-in ice maker and no water dispenser (the EZ Connect icemaker kit is sold separately), so dispenser, plumbed ice and water-filter symptoms do not apply to it as sold.
- The specific fault this record addresses: is leaking water
What it does not cover
- ×The same symptom on a different Whirlpool product line, which has its own record and its own cited source
- ×An on-screen error code whose meaning has not been checked against this exact model's manual
- ×Live electrical, gas, sealed-system, internal battery-cell or structural repair — a technician boundary, not a self-service step
Differential
What actually causes this, and how to tell them apart
These are ordered by how often each one is the answer, not by how easy it is to try. The point of the middle column is that two causes producing the same headline symptom rarely produce the same detail — that detail is what tells you which one you have before you change anything.
- 1
The defrost drain is blocked
What separates it Water pooling under the crisper drawers, or ice building up in the bottom of the freezer, appearing on a regular cycle rather than continuously.
How to confirm Every frost-free refrigerator melts its evaporator frost periodically and drains that water to a pan underneath. When the drain blocks with debris or freezes, the melt water overflows into the compartment instead. This is the single most common refrigerator leak.
- 2
The water filter housing or its connection is leaking
What separates it Clean water at the front or inside the fresh-food compartment, appearing right after a filter change.
How to confirm A filter not seated fully, or an O-ring left from the previous filter, are the usual causes. Remove and refit the filter carefully.
- 3
The supply line connection is weeping
What separates it Clean water at the rear of the unit or under it, present even when nothing has been dispensed.
How to confirm Check the connection at the refrigerator and at the shut-off valve.
- 4
Condensation from a door left ajar or high humidity
What separates it Water droplets on interior surfaces or around the door opening rather than a pool, worse in humid weather.
How to confirm See door-not-closing. Warm humid air entering continuously condenses on cold surfaces.
- 5
The drain pan is cracked or overfull
What separates it Water on the floor under the rear of the unit with no water inside the compartments.
How to confirm The pan under the unit is designed to hold defrost water until it evaporates. A cracked pan, or one overwhelmed by a genuine defrost problem, spills onto the floor.
Before you touch a setting
Record this first — changing settings destroys the evidence
Every item below stops existing the moment a reset, re-pair or settings change is made. Written down first, they are what separates the causes above; recovered afterwards, they are guesswork.
- Where the water appears: under the crispers, in the freezer floor, at the rear, or on the floor. Each points at a different source.
- Whether it appears continuously or on a repeating cycle, which points at the defrost cycle.
- Whether the water is clean supply water or has been sitting.
- Whether a filter was changed recently.
Determine whether the water appears on a repeating cycle
ReversibleWater that reappears every several hours follows the defrost cycle and points squarely at a blocked defrost drain.
Locate and clear the defrost drain
ReversibleIt is usually at the base of the rear freezer wall. Clearing it per the manual's method resolves the most common refrigerator leak there is.
Reseat the water filter and check for a leftover O-ring
ReversibleA leak that started right after a filter change is almost always the filter itself.
Check the supply connection at the unit and at the shut-off valve
ReversibleClean water at the rear with nothing dispensed points here.
Inspect the drain pan underneath for cracks or overflow
ReversibleWater on the floor with dry compartments points at the pan rather than inside the cabinet.
Model-specific
What is true of this model and not of its siblings
Generic advice for the product line fails here. Each item below is a property of this specific model family that changes which of the steps above apply to you.
- Model scope
- WRT318FZDW. Whirlpool WRT318FZDW top-freezer refrigerator. Whirlpool’s own specification for this model states no built-in ice maker and no water dispenser (the EZ Connect icemaker kit is sold separately), so dispenser, plumbed ice and water-filter symptoms do not apply to it as sold.
- Type — TOP-FREEZER (no dispenser, no ice maker)
- An entry TOP-FREEZER Whirlpool that ships with NO through-door dispenser AND NO factory ice maker (verified). Dispenser and ice-maker symptoms do not apply — you use ice trays and fill water by hand. Top-freezers are the simplest, most reliable layout.
- Optional ice-maker kit
- Some WRT models accept an add-on ice-maker kit, but as shipped none is installed — 'ice maker not working' means there is no ice maker, not a fault.
- Cooling
- A single cooling system, freezer on top. A warm fridge with a cold freezer is usually the down-vent to the fridge blocked by packed food or iced from a defrost issue — clear it and avoid overpacking the top shelf. Clean the condenser coil periodically.
- Symptom boundary
- This record covers Whirlpool WRT318FZDW top-freezer refrigerator when it is leaking water. A different symptom on the same hardware, or this symptom on a different Whirlpool product line, has its own record with its own causes and its own cited source.
Stop boundary
When this stops being a self-service repair
Continuing past any one of these costs more than the repair saves — in safety, in warranty, or in evidence a technician needs.
- !Close the water supply and unplug the unit for water spraying under pressure, a cracked supply line, or water reaching an outlet or wiring.
- !Water under a refrigerator that has been leaking for some time damages flooring and subfloor — check underneath and behind, not just the visible area.
Evidence ledger
Sources behind this answer
Visible sources support the visible claims. Home Product Support records the publisher, the fact used and the review date; community reports can suggest an issue but do not become a published fact on their own.
Where the manufacturer's article stops. Whirlpool Product Help publishes this as "Product Help". Official Whirlpool product help; this key exists so the top-freezer refrigerator cites Whirlpool's Top Freezer articles. What that article does not carry is the model boundary — it is written for a product line, and WRT318FZDW is the scope applied here. Where a control label, terminal, indicator pattern or reset sequence differs on your unit, the manual for that exact model is the authority, not this page and not the article.
Exact questions
Common follow-ups
How do I make ice in my Whirlpool WRT318FZDW?+
With ice trays — this entry top-freezer ships with no factory ice maker and no dispenser, so there is nothing automatic to troubleshoot for ice or water. Some versions can take an optional add-on ice-maker kit if you want automatic ice, but out of the box you fill trays and put them in the top freezer. It is not a fault, just the model's simple configuration.
There's water pooling under my crisper drawers.+
That is the classic sign of a blocked defrost drain. Every frost-free refrigerator melts frost off its evaporator periodically and drains that water to a pan underneath — when the drain blocks with debris or freezes over, the melt water overflows into the bottom of the compartment instead. The drain is usually at the base of the rear freezer wall.
It only leaks every few hours, not constantly.+
Water that reappears on a repeating cycle rather than continuously is following the defrost cycle, which confirms a defrost-drain problem rather than a supply leak. A supply leak would be continuous or tied to dispensing.
Does this answer apply to every Whirlpool model?+
No. It is scoped to WRT318FZDW. Whirlpool WRT318FZDW top-freezer refrigerator. Whirlpool’s own specification for this model states no built-in ice maker and no water dispenser (the EZ Connect icemaker kit is sold separately), so dispenser, plumbed ice and water-filter symptoms do not apply to it as sold.
What should I record before troubleshooting leaking or water under fridge?+
Record the complete model identifier, exact message or indicator, software/firmware where visible, the operating stage and what still works.
Why is a factory reset not the first step?+
A reset can erase accounts, networks, maps, schedules or preferences without distinguishing leaking, water under fridge. The ordered checks preserve that evidence.
When should I stop and use qualified service?+
Close water and unplug for spraying, electrical wetting or a cracked line.
Answer for the exact device and software version shown above.