Direct answer
For the LG WashTower WKEX200H washer section, residue, trapped moisture and a restricted drain path should be corrected before deodorizing. First, inspect the gasket, dispenser, filter and tub after removing laundry.
What this covers
- LG WashTower WKEX200H washer section (WKEX200H*)
- Stacked WashTower; this record covers the washer section and shared control panel.
- The specific fault this record addresses: smells musty, sour or like mildew
What it does not cover
- ×The same symptom on a different LG product line, which has its own record and its own cited source
- ×An on-screen error code whose meaning has not been checked against this exact model's manual
- ×Live electrical, gas, sealed-system, internal battery-cell or structural repair — a technician boundary, not a self-service step
Differential
What actually causes this, and how to tell them apart
These are ordered by how often each one is the answer, not by how easy it is to try. The point of the middle column is that two causes producing the same headline symptom rarely produce the same detail — that detail is what tells you which one you have before you change anything.
- 1
Biofilm in the door boot seal's fold
What separates it The smell is strongest at the open door, and pulling back the rubber boot's lower fold reveals black or grey deposits and standing water.
How to confirm This is the primary reservoir on a front-load washer and the first place to clean. It is not reachable without deliberately pulling the fold back.
- 2
The drain pump filter housing holds stagnant water
What separates it A musty smell that persists after the boot and drawer are clean, with the filter not having been cleaned in months.
How to confirm Clean the filter and its housing over a pan — the housing itself retains water and residue between cycles.
- 3
Residue in the dispenser drawer and its housing
What separates it Smell concentrated at the drawer, with visible slime or crust in the drawer recess.
How to confirm Remove the drawer entirely and clean both it and the cavity it sits in — the cavity is frequently missed.
- 4
The door is kept closed between loads
What separates it The smell returns within days of every cleaning, on a machine whose door is shut after each use.
How to confirm Leaving the door and dispenser drawer ajar between loads is the single most effective preventative measure, because it lets the seal and drum dry.
- 5
Habitual over-dosing of detergent or fabric softener
What separates it Recurring odor with heavy residue everywhere, and suds problems on ordinary loads.
How to confirm Excess product does not rinse away; it becomes the food source for the biofilm — see suds-foam.
- 6
Wet laundry is being left in the drum after cycles
What separates it The smell transfers to the clothes as well as the machine, and is worst after a load has sat.
How to confirm Removing loads promptly resolves the clothing smell independently of cleaning the machine.
Before you touch a setting
Record this first — changing settings destroys the evidence
Every item below stops existing the moment a reset, re-pair or settings change is made. Written down first, they are what separates the causes above; recovered afterwards, they are guesswork.
- Where the smell is strongest — the door seal, the dispenser drawer, the drain filter area, or the clothes themselves.
- Whether the door and dispenser drawer are left open or closed between loads.
- When the drain pump filter was last cleaned.
- Whether the smell is musty and organic, or sharp and electrical — the latter is a different and more urgent problem entirely.
Pull back the door boot seal's lower fold and clean the full circumference
ReversibleThis is the main reservoir on a front-load machine and cannot be reached without deliberately folding the boot back.
Clean the drain pump filter and its housing over a pan
ReversibleThe housing retains stagnant water between cycles even when the filter itself looks clear.
Remove the dispenser drawer and clean both the drawer and its cavity
ReversibleThe cavity the drawer sits in is routinely missed and holds residue.
Run the manufacturer's tub-clean cycle with the specified product
ReversibleDo this after the manual cleaning, not instead of it — a tub-clean cycle cannot reach inside the boot fold.
Leave the door and dispenser drawer ajar between loads from now on
ReversibleThis is the single most effective preventative measure and costs nothing.
Model-specific
What is true of this model and not of its siblings
Generic advice for the product line fails here. Each item below is a property of this specific model family that changes which of the steps above apply to you.
- Model scope
- WKEX200H*. Stacked WashTower; this record covers the washer section and shared control panel.
- Type — WashTower: stacked washer + dryer, one control panel
- The WashTower is a single unit with the washer on the bottom and dryer on top, sharing ONE center control panel between them. That shared panel is the key troubleshooting fact: a control-board or power fault can make BOTH halves misbehave at once, and a code shown centrally may belong to either the washer or the dryer — identify which section is affected first.
- Motor — Direct Drive inverter (no belt)
- The washer uses LG's belt-less Direct Drive inverter motor; noise/vibration is bearings and balance, not a belt.
- Smart
- ThinQ Wi-Fi with AI-sensing cycles. Front-load door gasket care governs washer odour; the dryer is a vented dryer needing normal lint/vent maintenance.
- Symptom boundary
- This record covers LG WashTower WKEX200H washer section when it smells musty, sour or like mildew. A different symptom on the same hardware, or this symptom on a different LG product line, has its own record with its own causes and its own cited source.
Stop boundary
When this stops being a self-service repair
Continuing past any one of these costs more than the repair saves — in safety, in warranty, or in evidence a technician needs.
- !A sewage smell rather than a musty one points at the household drain rather than the washer — check the standpipe trap rather than cleaning the machine further.
- !A sharp, acrid or burning-electrical odor is a different problem entirely: disconnect power and do not run the machine.
- !Never mix cleaning chemicals, particularly bleach with any acid or ammonia-based product, while cleaning a dispenser or seal that still holds residue.
Evidence ledger
Sources behind this answer
Visible sources support the visible claims. Home Product Support records the publisher, the fact used and the review date; community reports can suggest an issue but do not become a published fact on their own.
Where the manufacturer's article stops. LG publishes this as "[LG Washing Machine] Troubleshooting Musty Odors". Musty/sour/mildew smell and LG's gasket and tub-clean remedy. What that article does not carry is the model boundary — it is written for a product line, and WKEX200H* is the scope applied here. Where a control label, terminal, indicator pattern or reset sequence differs on your unit, the manual for that exact model is the authority, not this page and not the article.
Exact questions
Common follow-ups
Both the washer and dryer on my LG WashTower stopped working.+
The WashTower shares a single control panel between the washer and dryer, so a power or control-board problem can take out both at once — which a separate washer and dryer would never do together. Start by confirming power and doing a full power-cycle (unplug for a minute). If only the shared display is dead, that is the control panel; if both machines run but one section faults, treat that section on its own.
My front-load washer smells musty no matter how often I run a clean cycle.+
A tub-clean cycle cannot reach inside the door boot seal's fold, which is where the biofilm actually lives. Pull the rubber boot's lower fold back by hand and clean the full circumference — you will usually find standing water and dark deposits there — then clean the drain pump filter housing and the dispenser drawer cavity.
Why do front-load washers smell more than top-loaders?+
They have more places that stay wet between loads: the door boot seal's fold, the drain pump filter housing and the dispenser drawer all retain water after every cycle. A top-load washer has no boot seal at all and drains more completely, so it gives biofilm far less to work with.
Does leaving the door open actually help?+
Yes, and it is the most effective preventative step available. Leaving the door and the dispenser drawer ajar between loads lets the seal, drum and drawer dry out, which removes the moisture the biofilm needs.
Does this answer apply to every LG model?+
No. It is scoped to WKEX200H*. Stacked WashTower; this record covers the washer section and shared control panel.
What should I record before troubleshooting odor or mildew or smell?+
Record the complete model identifier, exact message or indicator, software/firmware where visible, the operating stage and what still works.
Why is a factory reset not the first step?+
A reset can erase accounts, networks, maps, schedules or preferences without distinguishing odor, mildew, smell. The ordered checks preserve that evidence.
When should I stop and use qualified service?+
Stop for sewage backup, smoke, overheating or chemical mixing.
Answer for the exact device and software version shown above.