Exact model-family answer directory

Maytag MHW5100 front-load washer troubleshooting

Choose the symptom actually shown by MHW5100D*. Maytag front-load washer; confirm the full model before interpreting F/E codes. Error codes remain separate records because the same characters can mean different things on another platform.

not drainingnot spinningnot fillingleakingshakingdoor locked

Reviewed records

18 exact answers

Not sure where the fault is?

Maytag · cycle too long

Maytag MHW5100 front-load washer cycle takes too long or keeps adding time

For the Maytag MHW5100 front-load washer, load sensing, suds removal, heating, balancing and slow fill/drain can legitimately extend displayed time.

Open record Maytag · not cleaning

Maytag MHW5100 front-load washer does not clean clothes well

For the Maytag MHW5100 front-load washer, poor cleaning is usually resolved by load size, cycle, soil level, detergent, temperature and water flow before parts replacement.

Open record Maytag · detergent not dispensing

Maytag MHW5100 front-load washer does not dispense detergent, bleach or softener correctly

For the Maytag MHW5100 front-load washer, wrong product, dose, drawer parts, low pressure and leveling can imitate a failed dispenser.

Open record Maytag · door locked

Maytag MHW5100 front-load washer door or lid will not unlock

For the Maytag MHW5100 front-load washer, do not force the door; most controls keep it locked while water, heat or motion is detected.

Open record Maytag · fills when off

Maytag MHW5100 front-load washer fills with water while turned off

For the Maytag MHW5100 front-load washer, water entering an idle washer points to an inlet valve that is not sealing or drain-water backflow.

Open record Maytag · no power

Maytag MHW5100 front-load washer has no power or a blank control panel

For the Maytag MHW5100 front-load washer, prove the outlet, breaker/GFCI and wake/control-lock state before internal electrical service.

Open record Maytag · leaking

Maytag MHW5100 front-load washer is leaking water

For the Maytag MHW5100 front-load washer, the location and cycle stage of the first drop matters more than the final puddle.

Open record Maytag · grinding

Maytag MHW5100 front-load washer makes grinding, squealing, clicking or banging noises

For the Maytag MHW5100 front-load washer, describe the sound by stage and speed before assuming a motor or bearing failure.

Open record Maytag · shaking

Maytag MHW5100 front-load washer shakes, walks or bangs during spin

For the Maytag MHW5100 front-load washer, load balance, shipping hardware, cabinet level and floor stiffness should be proved before suspension or drive repair.

Open record Maytag · SUD

Maytag MHW5100 front-load washer shows excessive suds, SUD or Sd behavior

For the Maytag MHW5100 front-load washer, excess or non-HE detergent can extend the cycle, suppress spin and cause drain errors.

Open record Maytag · odor

Maytag MHW5100 front-load washer smells musty, sour or like mildew

For the Maytag MHW5100 front-load washer, residue, trapped moisture and a restricted drain path should be corrected before deodorizing.

Open record Maytag · stops mid cycle

Maytag MHW5100 front-load washer stops, pauses or powers off mid-cycle

For the Maytag MHW5100 front-load washer, record the stage and display state; a repeatable stop during fill, heat, drain or spin is diagnostically different.

Open record Maytag · water level low

Maytag MHW5100 front-load washer uses very little water or the water level looks wrong

For the Maytag MHW5100 front-load washer, high-efficiency washers may not submerge the load; dry items, poor turnover or a fill code—not appearance alone—indicate a fault.

Open record Maytag · Wi-Fi

Maytag MHW5100 front-load washer will not connect to Wi-Fi or the manufacturer's app

For the Maytag MHW5100 front-load washer, prove appliance eligibility, supported Wi-Fi band/security, account ownership and onboarding mode before resetting the appliance.

Open record Maytag · not draining

Maytag MHW5100 front-load washer will not drain or stops with water inside

For the Maytag MHW5100 front-load washer, treat standing water as a drain-path problem until the pump, filter, hose and household drain are separated.

Open record Maytag · not filling

Maytag MHW5100 front-load washer will not fill with water or fills too slowly

For the Maytag MHW5100 front-load washer, verify both water supplies, inlet screens, hose routing and the selected cycle before treating the inlet valves or pressure system as failed.

Open record Maytag · not spinning

Maytag MHW5100 front-load washer will not spin or leaves clothes soaking wet

For the Maytag MHW5100 front-load washer, a washer normally refuses full-speed spin when it has not drained, cannot balance the load or cannot prove the door is locked.

Open record Maytag · door won't lock

Maytag MHW5100 front-load washer will not start because the door or lid will not lock

For the Maytag MHW5100 front-load washer, remove clothing pressure and inspect alignment before replacing a latch.

Open record

Confirm the model first

Which units this covers, and how to tell yours is one of them

Every answer below is scoped to these model identifiers. A neighbouring model in the same line can use a different part, a different reset sequence or a different radio, so matching the identifier before following a procedure is the step that decides whether the rest of the page applies to you.

Model numbers and patterns: MHW5100D*
What that covers: Maytag front-load washer; confirm the full model before interpreting F/E codes.

Published specification

What is true of this model and changes how you fix it

These are the properties that decide which procedure applies. Each is read from the manufacturer’s own published figures for this model, not carried over from a sibling that shares its retail name.

Type — FRONT-LOAD (Maxima): An older Maxima FRONT-LOAD washer with a door gasket; gasket care and the Clean Washer cycle govern odour and mildew.
Feature tier: PowerWash system and Steam on this generation; check your build for Wi-Fi before app troubleshooting. Deep Fill / water-level options cover bulky loads.
Fault codes & diagnostics: F#E# codes; Maxima front-loaders enter diagnostic mode by pressing any 3 buttons (except Power) in sequence within 8 seconds, repeated — useful for reading a stored code.

Where these figures were read. maytag.com MHW5100 (Maxima front-load), read 2026-09-01

Manufacturer support for this product line. Maytag Product Help — Product Help. Official Maytag model, use, installation, maintenance and error-code guidance.

Exact questions

Questions that only have an answer for the Maytag MHW5100 front-load washer

Each answer below uses this model’s own published figures. The same question asked about a different model in the line has a different answer, which is why it is answered here rather than on a general page.

How do I run a diagnostic on my Maytag MHW5100 Maxima?+

On Maxima front-loaders, within 8 seconds press any three buttons (other than Power) in a 1-2-3 sequence, then repeat the same 1-2-3 sequence. That enters the service diagnostic mode, where you can read stored fault codes and run component tests. It is the fastest way to see what the machine has logged before you start replacing parts.

Structured depth, not empty permutations

Every published record carries a direct answer, scope, ordered fixes, risk notes and sources.

Device and manufacturer hubs share a consistent record system, but each answer carries the relevant controls, fault boundaries, consequences and official support entry point for that platform.

See the publication gate