Home Product SupportIdentify a code

GE range or wall oven · exact code

GE range or wall oven code F3, F4: meaning and safe checks

F3, F4 means: The oven temperature-sensor circuit is open, shorted or invalid. Scope: GE, GE Profile and Café electronic ranges/wall ovens; exact suffix may narrow the failed circuit.

Direct answer

On the covered GE range or wall oven platform, F3, F4 means the oven temperature-sensor circuit is open, shorted or invalid. First, stop heating and record the code.

Definition versus diagnosis

The display names a detected condition—not an automatically failed part.

KnownThe exact manufacturer definition and operating state shown above.Not yet provenA replacement component, wiring fault or internal cause without controlled isolation.Next evidenceThe first safe observation or test in the ordered checklist below.

What this covers

  • GE range or wall oven models covered by the cited manufacturer code family
  • Displayed code or documented alias: F3, F4
  • The operating stage and conditions described by the source

What it does not cover

  • ×Another appliance type or original-manufacturer platform
  • ×A code that merely resembles these characters
  • ×Internal live electrical, gas, sealed-system or control-board repair
Try in this order0 of 4 completed

  1. Verify the exact code and model

    Reversible

    Photograph the complete display and model label. Code aliases in this record: F3, F4. GE, GE Profile and Café electronic ranges/wall ovens; exact suffix may narrow the failed circuit.

  2. Perform the first non-destructive check

    Reversible

    Stop heating and record the code. Do not clear the display before recording the operating stage and remaining water, heat or load state.

  3. Correct only the documented fault domain

    Reversible

    Arrange sensor/wiring service. Do not substitute a similar brand or product code table for the exact model manual.

  4. Verify or escalate

    Reversible

    Run only a safe short test that reaches the original stage. If F3, F4 returns, stop repeated resets and use model-specific manufacturer service.

Evidence ledger

Sources behind this answer

Visible sources support the visible claims. Home Product Support records the publisher, the fact used and the review date; community reports can suggest an issue but do not become a published fact on their own.

01
GE AppliancesRange and wall oven fault codes

Official GE common oven fault-code meanings.

Exact questions

Common follow-ups

What does F3, F4 mean on a GE range or wall oven?+

The oven temperature-sensor circuit is open, shorted or invalid.

Can I reset F3, F4 without fixing the cause?+

A reset may clear the display temporarily but does not correct the documented fault domain. Record the code and complete the safe checks first.

Why do I need the complete model number?+

Manufacturers reuse characters across different controls and product platforms. The full model identifies which official code table and service data applies.

When should I stop troubleshooting?+

Stop for smoke, arcing, burning odor, gas odor, uncontrolled water, electrical wetting or any condition the manufacturer directs to service.

Change recordAug. 17, 2026 — Published from the cited first-party GE code reference with explicit product scope and reset limits.
Report a correction
Wrong device or version?

Match the path before repeating the steps.

Match another device