On the covered GE range or wall oven platform, Loc Door means GE says that if LOC DOOR is flashing on the display and the self-clean cycle has not been selected, the controls need resetting. First, confirm you did not start a self-clean cycle.
Differential
Likely causes of “GE range or wall oven code Loc Door”, and how to tell them apart
- 1
Control Lockout was engaged
What separates it LOC DOOR flashes and self-clean was not selected, which points to control Lockout was engaged
How to confirm GE says first check the Control Lockout feature was not engaged; not all models have it
- 2
A control that needs its door switch reset
What separates it The lockout is not on and the flashing continues
How to confirm GE gives a reset using the door jamb switch or the manual latch
- 3
A door latch that is stuck partly locked
What separates it LOC DOOR flashes and the door will not open or close normally
How to confirm Check the latch has not been left half-turned and free it by hand only once the oven is cool
Before you touch a setting
Record this first — changing settings destroys the evidence
- The exact characters shown on the display: LOC DOOR
- Note whether Control Lockout is on before you start troubleshooting
- Whether the door switch is a small black post or a manual latch
Try in this order
0 of 5 completedWhat to do first
ReversibleConfirm you did not start a self-clean cycle.
Correct only the documented fault domain
ReversibleGE points to its guide on resetting the controls when LOC DOOR flashes in the display.
Check the lockout
ReversibleConsult the owner's manual for the model's Control Lockout feature and make sure it was not engaged.
Motorized switch reset
ReversibleWith the door open, push the small black door jamb post in until the cavity light goes off, press Self Clean and wait 10 seconds, cancel with Clear/Off as soon as it starts, and wait 10 seconds for the display to clear.
Manual latch reset
ReversiblePress Self Clean, close the door, slide the latch to lock it, hit Clear/Off or Cancel immediately, then unlock the door.
Model-specific
What is true of this model and not of its siblings
- Displayed as
- LOC DOOR.
- Parts named
- Door jamb switch; latch.
Stop boundary
When this stops being a self-service repair
- !Do not force the door latch, with the full model number and exact code ready
Evidence ledger
Sources behind this answer
Where the manufacturer's article stops. The two reset sequences are GE's own.
Exact questions
Common questions
What does Loc Door mean on a GE range or wall oven?+
GE says that if LOC DOOR is flashing on the display and the self-clean cycle has not been selected, the controls need resetting.
What does LOC DOOR flashing mean?+
The control believes the door state is wrong while self-clean has not been selected.
Is it the same as LOC?+
No; LOC is Child Lockout.
Should I force the door?+
No; wait for the oven to cool and reset it as GE describes.