On the covered Whirlpool range, F7 E0 means the oven door latch group reported a fault, which Whirlpool lists together with F7 E1 on the range control First, open and close the door and see whether the lock motor runs.
Differential
Likely causes of “Whirlpool range code F7 E0”, and how to tell them apart
- 1
The oven door latch motor stalls
What separates it F7 E0 shows when the door should lock or unlock
How to confirm Listen for the latch motor at the start of a clean cycle
- 2
A latch switch that does not report position
What separates it The motor runs but the control still sees no lock
How to confirm A technician tests the switch
- 3
Wiring to the latch
What separates it The code comes and goes
How to confirm Check the connector behind the oven
- 4
A latch that locks but does not report its position
What separates it F7 E0 at the end of a clean cycle, when the door should unlock
How to confirm The control waits for a switch signal after the motor moves, and times out when the switch is worn
Before you touch a setting
Record this first — changing settings destroys the evidence
- Whether the door is locked now
- Whether a self-clean ran
- Whether F7 E1 appears too
- The model number
Try in this order
0 of 6 completedWhat to do first
ReversibleOpen and close the door and see whether the lock motor runs.
Correct only the documented fault domain
ReversibleCheck the latch motor wiring and replace the door latch assembly if the code returns after a power reset. A power reset is the whole of what Whirlpool publishes for this code: remove power for 1 minute, restore it, and watch whether the code returns.
Let the oven cool
ReversibleWait until the oven is cool, since the lock will not release hot after a clean.
Reset the power
ReversibleSwitch the breaker off for a minute and back on.
Replace the latch assembly if it persists
ReversibleA latch assembly that fails its movement is replaced as one part.
Compare range and steam-oven codes before you act
ReversibleF7 E0 means a latch problem on a Whirlpool range, but the same characters name a water-level fault on a steam oven. Check that the appliance is a range with a self-clean latch before you follow the latch steps.
Model-specific
What is true of this model and not of its siblings
- Shown as
- F7 E0.
- Part named
- Door latch assembly.
Stop boundary
When this stops being a self-service repair
- !Do not force a locked door
- !Book service if the lock does not release when cool
Evidence ledger
Sources behind this answer
Exact questions
Common questions
What does F7 E0 mean on a Whirlpool range?+
the oven door latch group reported a fault, which Whirlpool lists together with F7 E1 on the range control
Is it the steam oven code?+
On Whirlpool wall ovens with a steam function, F7 E0 names a water level fault; on a range it is the latch.
Will the oven still bake?+
Some ovens bake with the latch fault, but the code stays until it is fixed.
Can F7 E0 appear without a self-clean cycle?+
Yes. The latch is also checked at power-up, so a worn latch can report the code on a fresh start.
What is the difference between F7 E0 and F5 E1?+
Both sit in the door latch family. The number tells a technician which part of the lock test failed, and the checks are the same.
Why is the oven door locked after a clean cycle?+
The control keeps the lock engaged until the oven is cool and the latch reports it is safe. A fault in that report can leave the door locked after the oven is cool.
Do I need to replace the whole oven control?+
Usually not. The latch assembly is the part that fails, and the control is checked last.