An appliance that will not run a cycle at all should be separated into power/door-safety interlocks, the selected cycle's own requirements and the specific component before assuming a major failure. For electric-dryer heat circuit, first test Timed Dry, reset both breaker poles once and verify exterior airflow.
What this covers
- electric-dryer heat circuit with this exact failure state
- Diagnosis across cycle setting/airflow versus 240-volt supply, heater and temperature controls
What it does not cover
Try in this order
0 of 4 completedCapture the exact failure state
ReversibleCheck whether the appliance powers on at all, whether the door or lid shows as fully closed and locked, and whether an error code displays. Expected behavior: receive both supply legs and cycle heat through protected elements.
Isolate the component boundary
ReversibleTest Timed Dry, reset both breaker poles once and verify exterior airflow. Try the simplest normal cycle with a light or empty load, keeping the door/lid and power connection unchanged. Boundary to separate: cycle setting/airflow versus 240-volt supply, heater and temperature controls.
Correct only the proven cause
ReversibleCorrect household power/vent or service internal heater/controls. Fully close and re-latch the door, clear the specific error code's documented cause, or restore power at the breaker.
Verify and stop safely
ReversibleRun one complete normal cycle and confirm it finishes without re-triggering the fault. Stop for breaker trips, hot plug, arcing, smoke or damaged cord.
Evidence ledger
Sources behind this answer
Exact questions