An appliance that will not run a cycle at all should be separated into power/door-safety interlocks, the selected cycle's own requirements and the specific component before assuming a major failure. For oven temperature control, first measure a standardized empty-oven cycle with an appropriate thermometer.
What this covers
- oven temperature control with this exact failure state
- Diagnosis across cookware/rack/measurement versus sensor, calibration and heating element/burner
What it does not cover
Try in this order
0 of 4 completedCapture the exact failure state
ReversibleCheck whether the appliance powers on at all, whether the door or lid shows as fully closed and locked, and whether an error code displays. Expected behavior: cycle around the setpoint after full preheat with normal variation.
Isolate the component boundary
ReversibleMeasure a standardized empty-oven cycle with an appropriate thermometer. Try the simplest normal cycle with a light or empty load, keeping the door/lid and power connection unchanged. Boundary to separate: cookware/rack/measurement versus sensor, calibration and heating element/burner.
Correct only the proven cause
ReversibleAdjust supported calibration modestly or service large/repeatable error. Fully close and re-latch the door, clear the specific error code's documented cause, or restore power at the breaker.
Verify and stop safely
ReversibleRun one complete normal cycle and confirm it finishes without re-triggering the fault. Stop for runaway heat, smoke, gas odor, arcing or breaker trips.
Evidence ledger
Sources behind this answer
Exact questions