Exact model-family answer directory
Electrolux EFLS617 front-load washer troubleshooting
Electrolux EFLS617 front-load washer (EFLS617S*): size (from Electrolux's spec sheet); cycles; dispensers; drum; rating plate; loading and balance, and a fix for each symptom below.
- Size (from Electrolux's spec sheet)4.4 cu ft, 38 in high, 27 in wide and 32 in deep to the center of the door arc (not counting the hose), with a 1,300 rpm maximum spin. A 15 in pedestal adds to the height.
Confirm the model first
Which units this covers, and how to tell yours is one of them
- Model numbers and patterns
- EFLS617S*
Published specification
What is true of this model and changes how you fix it
- Hardware — Electrolux product/support page4.4 cu ft, LuxCare Wash, Perfect Steam, StainSoak, SmartBoost, Perfect Balance System, 8 wash cycles — an older sibling of the EFLS627, no longer in production.
- Type — FRONT-LOAD (EFLS)A FRONT-LOAD washer with a door gasket; gasket care governs odor and mildew.
- Wash systemLuxCare wash system and Perfect Steam; a 15-Minute Fast Wash for small loads.
- Drain filterA drain-pump filter behind the lower panel handles most drain complaints.
- CyclesNine wash cycles and a steam cycle, including a 15-minute Fast Wash, Perfect Steam stain removal, Extend Refresh and a sanitize option.
- DispensersAn automatic detergent dispenser with SmartBoost, an automatic fabric softener dispenser and automatic temperature control.
- DrumStainless steel, and ENERGY STAR certified.
- Rating plateThe EFLS617 is a front-load washer from Electrolux, with its rating plate on the door frame. Write the model, product number and serial number in your phone, because the plate is hard to reach once the washer is in a closet.
- Loading and balanceA front-load washer likes a balanced mixed load. A single heavy item, such as a bedspread, can throw the drum off balance and trigger long spins or an unbalanced load message. Add a couple of towels to even it out.
- Seals and smellsMold smells come from a damp seal and drawer. Wipe the seal with a dry cloth after use, leave the door open and run an empty hot cycle with a washing machine cleaner once a month.
- Cycles and energyThe EFLS617 offers a range of cycles, including a quick wash and an option for heavy soil. Longer cycles on front-loaders are normal, because they use less water and heat. A time shown at the start is an estimate that changes as the sensors read the load.
- Care of hosesCheck the inlet hoses behind the washer every year for bulges and cracks, and replace them if they look worn. Reinforced hoses last longer. Turn off the taps if you go away for long, which protects against a burst hose.
- Parts, manuals and warrantyThe manual for the EFLS617 and its parts list are on Electrolux's support site. The most common parts people order are the door seal, the pump filter cap and the inlet hoses. A warranty claim needs the purchase receipt and the model and serial numbers on the rating plate.
- Good habits for a long lifeMeasure detergent rather than pouring, since too much leaves residue and strains the pump. Keep the drain hose free of kinks, run the machine empty with a cleaner now and then and stop the washer from standing on a soft floor. A level, solid base reduces vibration and wear on the bearings, which are the most expensive part to replace.
Where these figures were read. electrolux.ca/en/Owner-Support/Model-Support/?modeld=EFLS617SIW (Electrolux EFLS617SIW model-support page)
Manufacturer support for this product line. Electrolux Support — Product support. Official Electrolux manuals, product help and service entry point.
Also read for this model. Electrolux — EFLS617S front load washer spec sheet.
Exact questions
Questions that only have an answer for the Electrolux EFLS617 front-load washer
My Electrolux EFLS617 shakes during spin.+
First confirm the shipping bolts were removed at installation — front-loaders ship with bolts locking the drum, and leaving them in causes violent shaking. Then level the machine with locked feet on a solid floor and balance the load. Persistent shaking after those checks, or on normal loads, points to the suspension or an unbalanced heavy item, not a general fault.