Expanded exact-code directory
JennAir dishwasher error codes
JennAir dishwasher codes as JennAir Product Help lists them, each with its meaning and the first safe check.
JennAir dishwashers are built to sit in a high-end kitchen, often behind a panel, and many have a control that is hidden on the top edge of the door, which is why owners sometimes meet a fault code only when they open the door mid-cycle. This page lists the codes JennAir documents for its electronic-control dishwashers, each with its meaning and the first check, so you know what the machine is telling you before you call.
No records here yet.
JennAir dishwasher codes: reading the display on a premium machine
On a panel-ready or hidden-control JennAir the display may show the code only briefly, or as a row of lights along the top of the door. Open the door, read the display or count the lights straight away, and write the sequence down with the model number from the label on the tub edge; a technician can use that sequence to find the stage that failed.
The first checks are simple. Look in the filter for debris, make sure the spray arms rotate, confirm that the water supply is on, and check that the panel in front of the door is not rubbing against the control or the door. Cancel the cycle, switch the power off at the breaker for thirty seconds, then run a rinse to see whether the code returns.
If it does, the code usually names a drain pump, a fill valve, a heater or the control board. A JennAir dishwasher justifies the repair, but anything involving leaks, burning smells or the board is for a technician.
On a JennAir dishwasher the codes owners meet most are about the control rather than the water. F1 E1 means the control module reported a fault and, on older tables, a relay stuck on the electronic control board. F1 E2 and the FC codes name a communication error, which on a Wi-Fi connected model includes a look at the connection. F2 E1 reads a key as stuck, or the control did not see the door open or close, which on a hidden-control JennAir often means the door latch or the panel is rubbing the control. F4 E2 and F4 E3 name the heating system, and the sign is dishes that come out wet and cool.
Because a premium dishwasher has more electronics, the order matters: cycle the power for thirty seconds first, then check that the door closes and latches, then look at connectors, and only then think about a board. A board is the last part to replace, not the first.
Why can I only see the JennAir code when the door is open?
Many JennAir dishwashers have a control on the top edge of the door, so the display is only visible with the door open.
Where is the model number on a JennAir dishwasher?
On a label along the edge of the tub, visible with the door open.