Whirlpool range · exact code

Whirlpool range code Lo, Pre, ES, E5, Demo Mode: meaning and exact next steps

Lo, Pre, ES, E5, Demo Mode means the oven is below 170 degrees or preheating, Energy Save is active, or Demo Mode is on This answer applies only to Whirlpool, Maytag, KitchenAid, JennAir and Amana freestanding and slide-in ranges with electronic oven controls (electric, gas and dual-fuel). Ranges and wall ovens do NOT share a code table, and two code styles exist on ranges (F-codes such as F3 E0, and 1C/3d/4d/9d codes such as 3d11). Availability varies by model.

On the covered Whirlpool range, Lo, Pre, ES, E5, Demo Mode means the oven is below 170 degrees or preheating, Energy Save is active, or Demo Mode is on First, confirm the oven is heating normally. Then: leave Energy Save and Demo Mode by the key sequence in the manual.

Differential

Likely causes of “Whirlpool range code Lo, Pre, ES, E5, Demo Mode”, and how to tell them apart

  1. 1

    The oven is below 170 degrees or preheating (Lo, Pre)

    What separates it Lo or Pre shows right after you start the oven

    How to confirm Whirlpool says the display shows the temperature and rises in 5 degree steps once the oven reaches 170 degrees on some models

  2. 2

    Energy Save is on (ES, E5)

    What separates it The display shows ES followed by On and then goes blank

    How to confirm Whirlpool says the control sleeps after 5 minutes idle; press any key

  3. 3

    Demo Mode is on

    What separates it The oven runs its display but the elements stay cold

    How to confirm Whirlpool says Demo Mode lets you try the features without turning on the heating elements

Before you touch a setting

Record this first — changing settings destroys the evidence

  • The exact display: Lo, Pre, ES, E5 or Demo
  • Whether the oven actually heats when it is on
  • Whether the display sleeps after a few minutes

Try in this order

0 of 5 completed
  1. What to do first

    Reversible

    Confirm the oven is heating normally.

  2. Correct only the documented fault domain

    Reversible

    Leave Energy Save and Demo Mode by the key sequence in the manual.

  3. Read Lo and Pre as normal

    Reversible

    Whirlpool says Lo or Pre simply shows the oven is below 170 degrees F or preheating; a tone sounds when the set temperature is reached.

  4. Leave Energy Save

    Reversible

    Whirlpool says to press and hold Clock for 10 seconds to enter or leave Energy Save; the display shows ES followed by On or Off twice.

  5. Leave Demo Mode

    Reversible

    On a wall oven Whirlpool says to open Tools, choose Info, choose Store Demo Mode and set it OFF; ranges vary, so check the manual.

Model-specific

What is true of this model and not of its siblings

Displayed as
Lo, Pre, ES, E5, Demo Mode.

Stop boundary

When this stops being a self-service repair

  • !Arrange service if the oven never heats and Demo Mode is confirmed off

Evidence ledger

Sources behind this answer

Where the manufacturer's article stops. The 170 degree threshold and the 10 second hold are Whirlpool's own.

Exact questions

Common questions

What does Lo, Pre, ES, E5, Demo Mode mean on a Whirlpool range?+

the oven is below 170 degrees or preheating, Energy Save is active, or Demo Mode is on

What do Lo and Pre mean?+

The oven temperature is low (below 170 degrees F) or the oven is preheating.

What do ES and E5 mean?+

Energy Save is active; the display sleeps after 5 idle minutes.

How do I leave Energy Save?+

Press and hold Clock for 10 seconds.

Wrong device or version?

Match the path before repeating the steps.

Match another device