If the Samsung DVE45T6000 shows nothing when you press Power, Samsung's checklist starts outside the dryer: the door latched shut, the power cord in a live outlet, and the house circuit breakers or fuses. This is an electric model that needs 240 V across L1 and L2 at the outlet and normally two breakers, so a half-tripped pair can leave the panel lit but the drum cold or the reverse. Then check that Start/Pause was held rather than tapped, and that Child Lock is not on. Only after those checks is a display or control board fault worth a service call.
Differential
Likely causes of “Samsung dryer has no power or a blank display”, and how to tell them apart
- 1
A tripped breaker or blown fuse on the dryer circuit
What separates it The display is dark and other things on the same circuit also have no power
How to confirm Reset the breaker once or replace the fuse with the same rating; call an electrician if it trips again
- 2
The plug is loose or the outlet is not live
What separates it The dryer was moved or pulled out for cleaning just before it stopped
How to confirm Push the plug in fully and try a different appliance in the same outlet
- 3
Low or missing voltage on one leg of the 240 V supply
What separates it The display and drum work but the dryer does not heat or dries very slowly
How to confirm Ask an electrician to confirm 240 V between L1 and L2 at the outlet
- 4
Child Lock on, or Start/Pause tapped instead of held
What separates it The display lights but the cycle never begins because Child Lock is on or Start or Pause was tapped instead of held
How to confirm Look for the Child Lock indicator and hold Start/Pause until the cycle starts
Before you touch a setting
Record this first — changing settings destroys the evidence
- Whether the display lights at all when Power is pressed
- Whether a breaker is tripped and whether it trips again on reset
- Whether the plug is fully seated and the outlet supplies other appliances
Try in this order
0 of 5 completedCheck the door and Power
ReversibleClose the door until it latches, then press Power. Samsung's first checklist row for a dryer that does not run is door latched, cord in a live outlet, breakers or fuses fine, and Start/Pause pressed again if the door was opened during a cycle.
Check the outlet and plug
ReversiblePush the plug fully into the outlet. If the dryer was pulled out or moved, a plug that has worked loose is the commonest reason for no power. Do not modify the plug or use an adapter.
Check the breakers
ReversibleAt the panel, look for a tripped pair for the dryer. An electric dryer runs on a dedicated circuit, so reset the breaker once and never replace it with a larger one. If it trips again, stop.
Check Child Lock and the hold
ReversibleHold Start/Pause (Hold to Start) rather than tapping it, and look for the Child Lock indicator. To switch Child Lock off hold Dryness and Temp. together for 3 seconds.
Read any code
ReversibleIf a code appears, note it: 9C1 is an electronic control check that says to confirm power is supplied properly, and 3C says to unplug the dryer and contact a Samsung service center.
Model-specific
What is true of this model and not of its siblings
- Power supply on the electric model
- Samsung's electrical section says all U.S. models are designed for a 3-wire connection, that the frame is grounded to the neutral at the terminal block and that a 4-wire connection is required for new or remodeled installations. It says the wiring diagram is on the plate under the control panel or rear frame. Wiring and grounding must follow local codes, and it is the owner's responsibility to provide adequate electrical service.
- Parts for this problem on the DVE45T6000 (RepairClinic, 2026-09-21)
- assembly module;jog module,a pjt, part number DC92-02401A, at $140.95.
- Other models this page answers
- These steps also fit models DVE53BB8700, DVE50BG8300, DVG53BB8700, DVG50BG8300, DVG45T6000, DV45K6500, DV42H5000.
Stop boundary
When this stops being a self-service repair
- !If the breaker trips again after one reset, stop and call an electrician because that means an overload or a short
- !If the outlet is live, the door is shut and Child Lock is off but the display is still dark, contact a Samsung service center
Evidence ledger
Sources behind this answer
Samsung's support page for this model, which lists the manual and its revision date.
Parts and list prices as shown on RepairClinic's parts search for this model number on 2026-09-21.
Exact questions
Common questions
Why does my Samsung dryer not turn on?+
The first checks in Samsung's manual are the door latch, a live outlet, the breakers or fuses and pressing Start again if the door was opened mid-cycle.
What voltage does this dryer need?+
240 V between L1 and L2 at the outlet. Samsung notes that low voltage may stop it drying properly.
Can I run an electric dryer on an extension cord?+
No. The manual requires the proper grounded outlet and warns against modifying the plug.
Does the dryer need its own circuit?+
Samsung recommends an individual branch circuit serving only the dryer.
The display is on but nothing starts.+
Start/Pause is a hold-to-start button and Child Lock disables all buttons except Power, so check both.
Is the power cord included?+
On electric models the manual says the grounded cord is optional and sold separately, so an electric dryer may be hard-wired.