Fisher and Paykel expanded error-code library

Fisher & Paykel appliance codes

Fisher & Paykel dish drawers, washers and ovens signal faults by flashing lights or letter codes, and the pattern depends on the product line. Dish drawer errors are shown by the number of flashes on the display; note the pattern and the serial number from the label before contacting the brand. Power the appliance off at the wall for a minute to clear a temporary fault.

Fisher and Paykel DishDrawer dishwashers and washers show codes as flashing lights or numbers, and the number of flashes identifies the fault. Water in, water out and heater faults are the most common categories. A DishDrawer that will not drain usually needs its filter cleaned, and a washer that will not spin may have an unbalanced load or a blocked pump.

Note the code and the cycle, switch the appliance off at the power point for a minute and try again. Because several models use different platforms, read the code against your exact model. Faults involving the pump, heater or control board are for a service agent.

Fisher and Paykel DishDrawer dishwashers have two separate drawers, and a code can refer to one drawer only. The display or lights flash a number, and counting the flashes gives the code. Water faults often trace to the filter or the drain, and the DishDrawer's smart drive motor means electronic faults need a service agent.